Sun Microsystems V880 User Manual download pdf (Page 78)

Maintenance

78 Avaya CMS Sun Fire V880/V890 Installation, Maintenance, and Troubleshooting May 2006

23. If you just installed an XVR-100 graphics accelerator card on a CMS R3V11 V880,

continue with Installing the XVR-100 software packages (V880 and R3V11 only)

page 78.

Installing the XVR-100 software packages (V880 and R3V11 only)

The XVR-100 software packages must be installed after you install a new XVR-100 graphics

accelerator card. If you are replacing an existing XVR-100 graphics accelerator card, you do not

have to reinstall this software.

To install the XVR-100 software packages on a Sun Fire V880 system:

1. Verify that your CMS system is running CMS R3V11 by entering:

pkginfo -x cms

Note:

Note: Do not perform this procedure if your CMS system is running a later load of CMS.

The software packages were installed with the Solaris operating system.

2. Verify that the XVR-100 graphics accelerator card is installed.

Note:

Note: For information on how to install the XVR-100 graphics accelerator card, see the

Sun documentation that was shipped with the card.

3. Load the Sun XVR-100 FCS software disk into the disk drive.

4. Enter:

cd /cdrom/cdrom0

5. Enter:

./install

The system installs the SUNWpfbx.u, SUNWpfbcf, SUNWpfbw, and SUNWpfbmn

packages.

6. Enter:

/usr/sbin/shutdown -y -i0 -g0

The system shuts down and displays the ok prompt.

7. Enter:

boot -r

8. Log into the system as root.

The system reboots and displays the # prompt.

9. Enter:

eject cdrom

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 207 208

No comments

Sun Microsystems V880 User Manual Page 78