Sun Microsystems CP3220 User Manual download pdf (Page 49)

Chapter 2 Hardware Installation and Service 2-15

■ A telnet utility (Connect to the proper port on a Network Terminal Server to

which the Sun Netra CP3220 is connected.)

■ Another suitable serial communications program on the system console

For example, if you are using a UNIX system as the system console, at the UNIX

prompt in a command tool or shell tool, or serial port A, type:

2.2.4.2 Connecting Cables to the System Console Not Running the

Solaris OS

1. Connect a shielded serial cable to the serial console port on the front panel of

the Sun Netra CP3220 blade server (

FIGURE 2-3) or the Sun Netra CP32x0 ARTM.

2. Connect the other end of the serial cable to the serial port of the system serving

as the system console.

3. Set the serial communications settings to 9600 baud, 8 bit, 1 stop bit, no parity,

and no handshake.

2.2.4.3 Netinstall Boot Device Map

TABLE 2-2 provides a map of netinstall boot devices. You may need this information

to understand which MAC address is associated with the system IP address on the install

server.

For example, the Base Fabric interface is connected to the switch model-number in

slot 8 of the ATCA shelf. To install to this device, select the xxx Ethernet interface

from the BIOS setup menus.

# tip -9600 /dev/ttya

TABLE 2-2 Netinstall Boot Device Table

MAC Address Solaris

Device

Hardware

Device Connects to...

Switch Slot

Connection

0:3:ba.xx.xx.xn+0 /jointfilesconvert/526674/bge0 (BMC5715C) Base Fabric 0 Slot 7

0:3:ba.xx.xx.xn+1 /jointfilesconvert/526674/bge1 (BMC5715C) Base Fabric 1 Slot 8

0:3:ba.xx.xx.xn+2 nge0 (MCP55) mgtA (front panel)

0:3:ba.xx.xx.xn+3 nge1 (MCP55) mgtB (rear panel)

0:3:ba.xx.xx.xn+4 nxge0 (Sun 10 GbE

Multithreaded

Networking ASIC 10

GB)

Extended Fabric 0 Slot 7

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 134 135

No comments

Sun Microsystems CP3220 User Manual Page 49